ИБП HAT 5V для Raspberry Pi Zero

Uninterruptible Power Supply For Pi Zero

Power Your Pi Zero Seamlessly From Power Connection OR The Backup Batteries

Supports Recharging And Regulated 5V Output At The Same Time, I2C Monitoring

The UPS HAT (C) is an uninterruptible power supply module specialized for Raspberry Pi Zero series. It incorporates Li-po battery switching charger with path management, voltage boost chip, and voltage/current monitor which allows monitoring the battery operating status via I2C bus.

• Onboard spring pogo pins for connecting with Raspberry Pi Zero series boards
• Li-po battery recharge chip, with dynamic path management, more stable power supply
• Voltage boost chip, providing regulated 5V power output
• I2C bus communication, monitoring the battery voltage, current, power, and remaining capacity in real time
• Multi battery protection circuits: over charge/discharge protection, over current protection, and short circuit protection, more safe and stable
• Recharging indicator for monitoring the battery operating status
• Comes with development resources and manual

Designed For Raspberry Pi Zero Series

Bottom Pogo Pin Connection, Allows Attaching Other HATs On The Top

Real Time Monitoring

Monitoring The Battery Voltage, Current, Power, And Remaining Capacity Via I2C

When the voltage dips too low, it is possible to save files properly and then shutdown the system by software, to avoid any data loss

What's On Board

W zestawie:

1. UPS HAT (C) x1
2. 1000mAh Li-po battery x1
3. Screws pack x1

Dodatkowe informacje, przykłady oprogramowania itp https://www.waveshare.com/wiki/UPS_HAT_(C)

Moduł Raspberry oraz moduł LCD widoczne na zdjęciach, nie wchodzą w skład sprzedawanego zestawu.